slider

Solids and Surface Analysis

Two different Surface Sampling Methods have been developed for Advanced IMS. These methods are based on the desorption of the samples from the surface and subsequent detection by Advanced IMS with capillary inlet.

The desorption techniques are:

  • Laser diode module desorption
  • Thermal desorption module for desorption by hot gas stream
 
 

Applicatin of isomeric β-blockers separation

 

 

 

Explosives detection

The Laser desorption - AIMS  technique was tested for the detection of explosives. The explosives were detected directly from the surface without any further preparation. Measured sensitivities are 100 pg for TNT, 500 pg  for RDX, and 1.8 ng for PETN.

 

TLC-AIMS

The Surface Sampling Methods are suitable combination of high resolution,
high sensitivity Thin Layer Chromatography with Advanced IMS.

After separation of the compounds by TLC, the TLC surface is sampled by the Laser desorption - AIMS without any further manipulation or preparation. The position of the laser is fixed and the TLC plate is moved in the desired directions by the motorized micro-positioning stage. The method was successfully applied to analyze the TLC plates containing explosives (TNT, RDX, PTEN, 2,4-dinitro toluene and 3,4-dinitro toluene), amino acids (alanine, proline and isoleucine), nicotine and diphenylamine mixtures.

© 2017  MaSaTECH. All rights reserved.